F1 Rigging Couplers

F1 Rigging Couplers

F1 Under-tray Rigging Couplers

Listed here are a supply of machined aluminum Under-tray Rigging Couplers for 1/12 scale F1 applications.


You will find these in the rear floor pan area around the engine as shown in the pic below. Picture shows this actual part used on a FW14B model.

1/12 F1 rigging couplers

FW14B by Andy Mathews


Each coupler uses 2 pieces that fit into each other. The rod end ball is .047" (1.2mm) diameter with a .021" (.53mm) eye bore. Hex on the lower portion of the coupler is .032" (.81mm) with a bore through the center of .0135" (.35mm) to accept braided cable or wire up to .013" (.33mm) diameter that YOU will have to supply.

 

This package contains 12 pieces each of both part "A" and "B" to build 6 complete lines with couplers at both ends. Compatible Nut and Bolt pins for mounting is P/N #1251.

There is NO CABLE, NUT & BOLT PINS or PHOTO ETCH supplied here

Display: List / Grid
Show:
Sort By:
1/12 F1 Rigging Couplers
#1490  1/12 F1 Rigging Couplers   This package contains 12 pieces each of both part..
$24.00
Powered By OpenCart
RB Motion © 2017